Standard Feature on every DR5000 is Status LED Indicator located below the Keypad.

The Status LED Indicator [green] provides the following to an operator:

LED is not on:
- Indicates there is no power to recorder

LED is on steady & pen(s) within chart range:
- Unit is operating normally.

LED is on steady & pen(s) above 100% mark on chart.
- Unit is in Change Chart Mode; Action - depress Change Chart Key to return to normal operation

LED Flashing RAPIDLY & pen(s) within chart range:
- Indicates optional 9VDC battery is low; Action- replace battery.

LED Flashing RAPIDLY & pen(s) at 0% or 100% of chart range:
- Indicates sensor break or PV is out of programmed chart range

LED Flashing Slowly [0.8 seconds]:

Unit in Set up or in Sensor Offset Mode:

Sensor Offset Mode: Complete Offset and/or unit will time out in less than 10 seconds and return to normal operation

Set up Mode: There is no time out in Set up Mode; complete Set up or power down & up the recorder to exit Set up.

Return to:

DR5000 Recorder.htm
DR5000 Thermal Recorder.htm
DR5000 Configuration Setup Chart.htm
DR5000 Display Option.htm

DR5000 Non-Catalog Options.htm

Main Recorder Page.htm

Products Page.htm

Future Design Controls 888.751.5444 csr@futuredesigncontrols.com